Q&A Forum
Hi,
I going to set up my HUBdyno.
I installed the latest software on my PC.
In the settings (Basic dyno setup / Brakedyno w/load cell) the secondary loadcell not showing up any live data.
then I insatlled same insatller on my secondary PC and it works as I expected.
also at the "Brake controller setup" have differences on the 2 PCs
On the working machine no "Controll brakes independently" menu item.
screen shots are attached, the first pic is from the working machine, the other 2 is the NOT ok.
any tips ?
Hi,
The Raw reading is at 0 which means the YourDyno box thinks you have only 1 load cell but the software thinks you have two. I have not seen that before. Make sure to use the latest firmware and if necessary do a disconnect/connect. Also make sure both PCs use the latest software.
Latest software and latest firmware, the hardware is on my desk with 2 load cells One PC is works fine then puged the usb to the secondary PC and don't work.
BTW the secondary load cell reading is not "0" instead some text like "NaN".
both windows are uptodate and uses latest .NET 4.8
Whats the specs of computers?
Are they power from wall (desktop or battery laptop)?
If you go into run window wants the Data sets per second reading on both computers?
Have you tried multipal USB ports, are they all USB2 ports?
What version of windows? If less then Win 10 did you manually install driver?
Or is there anything else you can think of thats different between computers.