Q&A Forum
What is everyone using or going to be using for engine rpm(not roller rpm)? Is everyone going to go with the dtec rpm adapter or is there a better solution? Are you using a clamp style sensor for the ignition pickup? I would really like to be able to use a clamp on probe for ease of use. Feel free to post a picture of your setups!
Thanks
I use the DTech tach adapter.
http://www.dtec.net.au/Dyno%20RPM%20Adapter.htm
This is the inductive pick-up/wire/clip I used.
https://www.pegasusautoracing.com/productdetails.asp?RecID=5109
It clips on the sparkplug wire, but I think just a length of 16-18 gauge wire would do the same thing.
Jeff
Schroedter, all setups MUST have the roller RPM sensor. This is where the power is calculated, and has requirements on number of teeth, etc.
In addition you can use an engine RPM sensor to automatically calculate the gear ratio.
The DTech adapter works fine with YourDyno.