Q&A Forum
Notifications
Clear all
Topic starter
Hello,
Here is my 1st run with my HUB dyno while trying to set the MOI.
All 3 lines are the same run, 1st (red) is the real run without noise compensation.
The 2nd (blu) and 3rd (grn) are the loaded RAW datalog of the red line with different noise filtering settings.
why the blu and grn are differs in the Tq values/slope ?
(also the enviroment data should be readed from the datalog, when a LOG file is loaded)
This topic was modified 5 years ago by HondaRulez
Posted : 15/07/2019 7:11 am
Hi, that difference in the start is due to the the initialisation of the digital filters. You use the raw logs to adjust noise settings, MOI, etc so this start effect does not matter in practice. It is of course not there for real runs.
Posted : 15/07/2019 6:44 pm
HondaRulez reacted