Q&A Forum
When I change the number of the moment of inertia associated with this brake, nothing changes in the chart.
Can anyone tell what I'm doing wrong?
With the previous software version it was working, now I have installend version 3.2.102 I have this problem.
Thanks a lot!
Hi, have you turned on "Compensate for inertia effects during acceleration"?
Good evening,
Thank you for your reaction.
The compensation for inertia effect is turned on/checked.
I' ve also tried the old version of the software one more time but without any result.
I know from before that the moment or inertia of my bank is around 5.4.
Is it possible that I send you the config file and a log file with the power curve so that you can have a look at it?
Thanks!
Daniël
Hi,
Sure, send the saved config and a log file to jostein@yourdyno.com
What I found that I had to do was to change the moment of inertia setting, then load the raw data file and it would change the graph. If I want to compare another moment of inertia setting I have to change the setting then go back and load the raw data file again to see the difference. It would not automatically change the graph that was already showing.
James
@james-meyers
Thanks James for your reaction.
That' s exactly the way I do it. I've done it with real runs and log runs and it worked before with the previous software version, until now after the update.
I checked your settings and saw what was wrong. The "Compensate for inertia effects during acceleration" option was off.
You also had the brake in manual mode. When you have brake in manual mode and "Compensate for inertia..." on you get a warning saying this is normally not a good combination, and asked if you want to turn off "Compensate...". You probably did that, because I remember I mentioned earlier that the "Compensate...." option needs to be on.
I checked your MOI, it is about 9.3.