Q&A Forum
Notifications
Clear all
Questions, answers and shared experiences
2
Posts
2
Users
0
Reactions
780
Views
Topic starter
Not a priority but something that would make running the dyno easier for me (Water brake engine dyno in load control mode).
It would be nice if when entering brake setup to set my sweep parameters that the last opened page was the first to display ( I have to click load control tab each time) Even better would be when in your control mode, the sweep, run start rpm and finish rpm could be set from the brake control box on the main control screen. During a session I may alter the finish rpm a dozen times, in and out of screens.
Posted : 15/06/2022 5:36 am
Agree with this one also. All of the common control items should be on the main control screen to try to make it quicker to setup and run if at all possible. Thanks
Posted : 13/07/2022 9:13 pm