Q&A Forum

Notifications

Clear all

Looking For Input on PID Settings

Questions, answers and shared experiences

Last Post by Jostein 2 months ago

4 Posts

3 Users

0 Reactions

877 Views

RSS

PhilStubbs

(@philstubbs)

Posts: 19

Member

Topic starter

I have attached a log of a run, hoping to get some input on PID settings for a water brake. Right now they are all .5 except for Kp, that is at .75

I haven't had a ton of luck even swinging those all over the place.

Test1_1_2.csv

Posted : 10/09/2024 10:03 pm

Jostein

(@admin)

Posts: 1460

Member Admin

Hi,

The trick is to look at the tab called Brake setup analysis. Click on New tab and create it from the template if you have not done that already. There you see that Kd is much too high and causing all the oscillations. Default is 0.05, and you may want even lower than that.

You can also try Load Control with Gain of 15 and Derivative of 0.03 for example.

Posted : 10/09/2024 10:46 pm

bwatson

(@bwatson)

Posts: 4

Member

@admin

I'm not able to find the tab called "Brake setup analysis". Can you provide guidance please? Using software 3.3.74.

Thanks

Posted : 02/10/2024 3:38 pm

Jostein

(@admin)

Posts: 1460

Member Admin

@bwatson Click New tab and choose Brake setup analysis from the templates.

Posted : 07/10/2024 12:23 pm

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed

Q&A Forum

Looking For Input on PID Settings

Have Questions?

Address