Q&A Forum
We moved units and moved our Dynatest 112 to the new unit.
We reconnected it and it now does not give us a torque figure. the speed and rpm seem ok but the bhp is very high.
Not sure if this is ok to put on here, but we carnt afford to buy new units yet, but in a mess now and no idea who to ask :-<
@radics1 well it has only 1 speed sensor so when we moved the speed sensor label fell off. but i know it had a bridge wire.
I have tried it in both modes and when you get the box chart where when you turn it on they go to 0. they all do except the torque figure.
i have tried it in both static and dyno mode. the box with the 4 items rpm, mph, torque and bhp move except the torque figure.
@radics1 It has a silver speed sensor on the right hand front roller.
On the 4 boxes that show Revs, MPH, BHP, Torque.
All the 3 (rev, bhp, mph) work but the torque figure is not moving just staying at a static figure.
The bhp when finished a run is just silly high or maybe even just a default figure.
We put a 150bhp car on the dyno and it showed 348bhp.
which is the setup window ? the 4 boxes ???
@radics1 i havent seen that screen before. is it from the items purchased on here? if so i dont have.
All i have is the blue unit with the dials on which i assume is original
it worked perfect 2 days before the move