Q&A Forum
Topic starter
Hi,
Is it possible to filter individual inputs? Both of my RPM sensors are solid, but my strain gauge output is pretty noisy. Is it possible to just filter this input channel and leave everything else alone?
Thanks,
Dave.
Posted : 03/01/2022 12:11 am
Thdyno reacted
Did you ever figure this out Dave? I have the same issue. Sweep\ramp runs are fine but the noisy signal from the load cell makes steady state tuning impossible.
I'm going to try a low pass RC filter, but a software filter would be easier.
Posted : 23/05/2026 11:44 am