Q&A Forum
@admin
Trying to setup my coolant temp sensor GM #213-928. I calculated all of the voltages that should be read using a voltage divider calculator.
Problem is that it never seems to get over 120 degrees F. I even attempted to adjust the temp to voltage chart so that it would read higher and it still doesn't show correctly.
I measured the voltage at Aux 2 input and it was .305 volts. I then used a temp gun to check the temp around the sensor, 160 degrees F. I then adjusted the table for that one specific temp and the run screen still showed me 112 degrees.
What am I doing wrong????
Thanks
James
I figured it out myself. I had put in the voltage values in a descending order, the software didn't seem to like that. I then changed it to an ascending order and it works perfect.
Good you got it to work!