Q&A Forum

Hello, I would go higher, my valve needed more . Check your valve by testing about 100mm out from center with a "type fisching scale) whats needed to ...

@boz-race-engines The control you are showing is for a steppermotor I think..simular to mine and in the amount of steps from zero to full open is co...

Well I have a watervalve that need some tourqe to turn...the land &sea valve I think operates easier. br/hakan

Im using a stepper motor with gearbox 20:1 Nema 23 3 revs closed to open BR hakan  IMG_6361.JPG

By the way are you or other using stepper motor for water cntrol?? If so what stepper motor and driver are you using ( unidirectional or bidirectiona...

Thanks Walter, I was looking at the "output connector" with 4 wires but see now what you mean! Thanks

Ok read true your info, 1 the your dyno box and the MTX-L plus needs to have the same minus= 0V thats the 0V on the AUX1 go to negative on the MTX...

As said in my post of RPM reading ..its now ok with loacell reading ...its stabil now! Hade wrong parameter of gear ratio! Thanks

My mistake, had wrong input in gear ratio for my waterbrake, should be 1.0 for direct engine to brake connection. This also cured my loadcell reading...

A picture of the whel and sensor Hakan  IMG_6307.JPG

Have made a wheel with 20 teths but the reading is of...if I put in 30 teths in the program its more normal reading. The wheel is Diameter 100 mm 2...