Q&A Forum
Ok, I found the problem , it was some files mising in my win 7 setup. Its ok now!
I had problems to but mainly due to using non resistor sparkplugs. After using resitor plugs it is fine.
Hi Einar, I have the same setup, homemade waterbrake and steppermotor to control watervalve and also have problems with the regulation of the sweep. H...
OK, tried to wrap aluminium folie around the sparkplugg wires....dont do that..sparks jumping between the wires and noise got worse ! After installing...
@turbo-dub Yes I use different ignition cables now, yellow siliconcables. But I realised that Im using "non resistor plugs" Bosch W 8 AC....mabe tha...
Thanks for all your help, Im going up to the mountains this coming week riding snowmobile...no electrical interference up there..but will continuing f...
So I located the EMI disturbance the loadcell. When motor runs and the loadcell conneted USB dropps directly after start, so I routed the loadcell cab...
Tried that ..no effect.
With aux 1 lamda and loadcell disconnected the USB is up and running with the motor running. Connect them to blue box while motor runs...Usb goes down...
More photo IMG_6392.JPG
Its a VW aircooled engine on my dyno stand, sep 12 v battery to the engine and grounded stand...Bosch red coil ignition ...sitting about 1 m from blue...
@admin Loadcell is working (giving data) when engine is not running but cuts USB if I plug it in sensors to blue box when engine runs.. or direct af...