Q&A Forum

Can i put maximum pulse widht up to 100% ? Now its only 60%. 2pcs CC160 should able to brake 3200Nm from hubs and with 3.91 ratio there is only ~2...

@adminFinland, can i change it somewhere?

Just looked and i dont have an analog input, its optional. How should i figure out duty cycle and frequency?Signal period 416 ms, am i right? Maximum ...

@adminWhy analog rather than PWM ?

I have also some trouble with power sweep. Using hub dyno, two Telma CC160.I think that low inertia is the cause of the problems, and tried to adjust ...

Telma Hub Dyno

One question, if i wire new coils to series, how i check the polarity? With compass, or is there any difference how i connect them...? E: Second que...

(HUB Dyno 2500hp) part2 vlogg #5

More:3000W Switching power supply output 72v 80v 90v 110v 200v dc, INPUT 110/220VAC AC-DC SMPS POWER SUPPLY Switching Power Supply adjustable voltage0...