Q&A Forum

Also is there a way to turn our monitors sideways? Much like dynapack software, so for eg instead of having our power and torque graph in one monitor ...

@cmadmin thanks for that. Went to enable canbus but it says “CAN bus output is not activated. Please contact YourDyno to activate CAN bus functionalit...

That’s great Jostein. Well done. So to confirm, we can now run the haltech WB01 controllers standalone into unavision?

Can confirm all working correctly again once updated and settings imported over from old version thanks Jostein

Thanks Jostein I will import the original settings from yourdyno into UnaVision first. Then see if it still acts weird or if it’s some setting I’ve fo...

Awesome work on the upgrade! Love the data setup. Makes searching runs so much easier now. I have an issue where the roller size isn’t staying upda...

Awesome. Thank you for the help. I may try set the software to lock converter down low and release it before the torque comes in heaviest. The 4l60...

Thanks for the reply Jostein. Do you mean the gear ratio changes because of the torque converter torque multiplication? Basically majority of th...

Thanks Jostein, I think my MOI maybe out a little, I will further calibrate. However, i did get to the bottom of this. All a steep learning curve! ...

Thank you for your swift reply, I have just looked at that tab and you are right, the brake is off. The target RPM seems to be 1500rpm, the log starts...