Q&A Forum
Is no one using the obd plugin?
Hi is anyone using the obd scantool Am i doing something wrong? Im only alowed to view a few parameters/livedata. And some of them dont even upd...
I use around 1-2mm
It works fine on my setup
Hi.
Maybe a dump question but i try anyway
Why are you using an device that converts from 0-5volt to pwm when the yourdyno can output pwm sign...
Hi i have a diy dyno made with 2 48" rollers from a dynojet. I use 48 teeth works fine The max speed i have been doing is around 260km/h
Hi. From josteins explanation to software149 i see that in case of lost comunication the brake turns of after a few seconds. Could it be an soluti...
Hi. I have had kind of the same problem. My sollution was to ground the dyno frame,brake, screen. and the cabinet that is housing the yourdyno a...
Anyone
Hi Hi the same here Whp is reading low especialy in higher speeds. The fan in the eddy current brake is consuming quite a lot. I did another...
@admin
thanks!
that feature is really an super upgrade
@radics1 Hi. On inertia run its the same whp is the same in 3 and 4 gear. The losses increase at higher rpm. And i think its from that the hp...
@radics1 The car is a ford fiesta 1.5diesel around 85hk. In the losses test i ran inertia only. So the loss measurement is not depending on the...
@radics1 In the red curve i drove around 245km/t I did place the dyno on the floor in the garage then placed the car on a hoist. And when i rea...
torque 3vs 4 gear and losses with no car fiesta-torque-3gear-4gear-and-car-lifted-of-rollers-during-coast-down.pdf