Q&A Forum

how do you control the pressure on the pump? With my setup its hard to make a upward rpm sweep without getting pig tails in the curve. If I sweep down...

is it a eddy current brake? then yes the faster it spins the move power it can take as the cooling airflow is normally proportional to the rotor speed...

Ok and what about the loadcell calibration?

I am in a similar situation but it seems not all options get transferred, for example can devices and math channels arent. is the dyno loadcell...

Ok so best to use a LM1815 ????

Hmm ok yes I wasnt brave enough to feed a 30v sine wave in ???? but good to know that it is capable of just hooking it to a standard VR crank sensor??...

Its seem as the manual on the website is not correct for a V5 hardware as there ir says the Engine Rpm input (most left one on the unit) has an intern...

@angelo Yes that should be a definable time over which the data is averaged. that way channels that are noisy or have an oscillation will not impact t...

Ow thats a quick fix! Ill give it a try as soon as I have the engine back together. Is there a way to filter or make a rolling average of channels? Fo...

Would it be possible to have a mode to use the software more like a steady state engine dyno? Controlling the hydraulic dyno I built to make a monoton...

It seems there is a bit of a bug in the Math Channel plugin. Lets say one defines in line 1 a formula and then wants to use the result of that formula...

Ok so we got it work using these formulas. Maybe it could still be good if Bmgjet could just add a checkbox in the CANTool window to treat a certain m...

A friend of me helped a bit and it is going into the right direction. this formula works now only when lambda goes below 1 the output is still wrong, ...

The window help specifies to look about the microsoft math class so if I look it up on google I come here and this say I should be able to write Hex(v...

Ok thanks for the tip!, Ill give it a go tomorrow and report back