Q&A Forum

Tuner Nerd knock is not stable yet for the graphing , he is developing that. He has a teaser on his facebook page but said it's not ready for sale . W...

Just to confirm , my rollers will top out at 3000 rpm max so that's 3000 divided by 60 makes 50 rpm sec. So minimum 4 slots, I suppose 6 would be a...

Ok thanks , seems I misunderstood. I've read so much stuff in a short time . That's why I said I'm not sure. The sensor wheel on mine is a thin disc w...

I'm sure somewhere i read on this forum you only need two teeth for load bearing , and more only needed for inertia. Could be wrong though. Pretty eas...

I'm dealing with tuner nerd knock, he's developing software with the aim to be like plex knock without the timing. It is a bit buggy atm but he works ...

Thanks , I'll stop playing till i get the hardware then .

So all the changes have to be made after a run while connected to the hardware? Because none of that works on my software but i don't have the hardwa...

This is probably too late . Anyway an option that might be worth thinking about . The megasquirt ms3 pro ecu could be used instead of the innovate pl...

another demo better illustrating our purpose

More demo

8 turns in less than 8 sec here . So these might be good and with the power they have i could do twice length on servo arm to valve arm to double spee...

I watched the servo being tested on youtube and it did about 1 rev per second so thats only .2 sec odd per 60 degrees

Does the software have to be plugged into the yourdyno hardware to use all options ? I just tried the V , the dialogue box comes up but it actually do...