Q&A Forum

@admin HelloThe power will be about 650HP and about 750NM I want to move around here. I was going to keep the Frenelsa but when they disassembled ...

@walter The idea was to make 2 rollers. I don't know if 300mm or 500mm can't find information that is independent and joined by a bending device. ...

@walter So will this brake be enough to boost 600hp?The 60mm bar will then be enough to make the shaft and what type of bearings would be the best s...

@admin Good morning, ok I will look on facebook thanks

Thanks for answering, the power as much as I can, my bmw now has 450hp, but I am going to raise the power to about 600hp, could the brake support that...

Hi Mach1, I did not want to do that type of dyno because I would have to make couplings for all wheel sizes, find 2 equal brakes.So I want to make a 2...

Hello again, I will manufacture the rollers, since I have tools to do and it will be the most economical, today I will try to locate a more powerful b...

Hello Walter, where are you from? The idea is for low-power cars, but for example my bmw already has 440hp and 495nm and with a view to increasing t...

This is the donor, I hope it is the right thing.  IMG-20200511-WA0015.jpg

Thanks for write.The brake that I am going to serve is a frenelsa f16-140.The power for what I want to do is in the 650Hp environment, I wanted to mak...

Hello Jostein, but from where do I have to choose the file?