Q&A Forum

@eric91 Hello again any chance I can give you a call and get some advice?Ash

@eric91 Hello again any chance I can give you a call and get some advice?Ash

It's best to use hand controle for throttle, if you use a pivot point and make it stiff to move you can apply throttle and leave it there why you play...

Hi Derk Can you post some pics of your flow valve setup.. I've tryed everything to get mine to work and it's useless. I used nema 17 with 3.7/1 to o...

I'm using a 60lph needle valve and a 100/1 ratio stepper motor with a adaptor I made up between the two. again a massive pain to do not tested since I...

It's got a under plug thermo temp sensor so i use the 0 to 5v from the converter and set the input on the fan controle pcb to switch on when it goes a...

One of them Is egt 0 to 5v converter as i needed 2 thermo temp sensors and the other one is a temp sensor to switch on the fan to cool the engine down

This is it all done 20180512_181830.jpg

Box full of tricks lol received_10156126418418898.jpeg

This was mock up received_10156146667093898.jpeg

I'm very intrested in this controle valve setup as I think the stepper motor way will work but not grate way to do it. Moog valve would be much bette...

I've done this using a 25cc pump I'm still having problems with controle. When the valve is under pressure from the pump it gets very hard to turn. I...