Q&A Forum

You mean the load to be applied in compression instead tension?If we assume that the load cell works in both direction (tension and compression) and h...

In addition, the shunt calibration could be used. It is just a modification (one resistor) of the load cell - that what is used to check the performan...

Just a quick update... The Opto-Isolator has been ordered and connected - everything works. Thank you!

@Rub87 for sure, as alternative way, not instead. The reason of direct sensitivity input is to make the calibration easier under certain circumstances...

Hi Jostein, Could it be possible, e.g. in future software releses, to calibrate the Load Cell differently?The load cells, as we use for the testing ...

Please check the version before you buy it - they have Chineese and Inernational. I've read somewhere that Chineese variant doesn't work properly.

Just tested with with 0.5k - there are 1.938V and 4.2V corresponding.

Hi, I have measured the sensor twice with 1k pullup and without. Without pullup the steady state is 0V, after the optical path triggered the outpu...