Q&A Forum

Hello everyone ,We have a new short video online, perhaps it is interesting for you. Regards, Derk

Hi Jeff,We do not know yet we have not come through all the faults to fully operate the valve. Up to 100 bar no problems seen. We have developed a new...

Hello everyone,Part 4 is online now!The run we did was good, unfortunately we did not test the engine, we got an electronic fault just before the star...

Hello, Of course I want to put photos on the forum, but you do not have much of a photo. Tell me more about your project, maybe I can help you better....

Now online

Dear members,Today I received the Murata Shock Sensor Board, the first tests on a 12v electric motor seem satisfying. At the end of this week I will p...

Hose material internal: NBRHose material external: SBRHose type: HST-13 -2SNPillar A: Swivel (M22 x 1.5)Pillar B: Swivel (M22 x 1.5)Item type:Complete...

Hello Jeff, For the hydraulic valve i used a Nema34 Stepper Motor 34HS1450D12.7L34J5-5 Single KEY WAY Shaft 8N.M 4leads 5A 114mm motor lengthDM880H...

thanks for your reply, the 3rd episode is online now. Regards, Derk

Part 2 is now online

Hello to all, I want to try this, follow this link Derk