Q&A Forum

Hi, If you have an auto gearbox and run with fixed gear ratio, then the torque reading will be wrong. This is because the gear ratio changes during ...

Yes, this makes sense. If the Engine RPM is below the Target RPM, then the brake will be off. In this case it will run as an Inertia dyno which, if th...

This is normally a problem between the PC and the monitor, caused by bad cables or vibration. I have seen this in a couple of setups, where all looks ...

Click the button under Configure on the channel in the CAN setup. This is the curve that can translate from C to F (or any other translation). Click E...

Go to Options->CAN bus. Make sure it is enabled and set to 500kbit/s. Go to CAN input channels and select the AEM 8 channel thermocouple module ...

Hi, I did a quick test with a Snapdragon laptop earlier and it worked. I am not 100% sure if everything is compatible, though. I did not test Blueto...

You can contact Klam brakes at luis@zelusl.com in Spain. They have brakes that can go this high in RPM and they can recommend the best brake for you...

If you use Power Sweep and have a hold time of 2 seconds, then it will hold that RPM for 2 seconds using the brake, then after 2 seconds, the sweep st...

Here is how to see what happened: Create the Brake setup analysis tab if you don't have it already Go to that tab and check the Engine RPM vs Tar...

You can use RPM2 for turbo speed.

We need more information to know what is going on. For these things mails are better. I will answer on mail.

It uses the KmTronic plugin in YourDyno. You select it when installing YourDyno.

There are many ways it can be done. There are some tips and tricks in the software manual, see chapter 13.1 Finding the right Moment of Inertia (MOI) ...

We recommend this clamp:/p> Replace the cable with a shielded cable.