Q&A Forum

@thdyno What do you use for the lever length when calibrating? The mounting on the inside? The mounting on the frame? Or the middle of the load cell...

Yes, that is what I had suspected....I believe I will need a separate power source. I speculate the amperage requirements are minimal? Perhaps 500m...

@danny_530 Were you able to use that load cell? I have something similar and am converting a Maha/Sun emissions dyno to a small engine dyno. Chipg19...

It seems that my best option is to purchase your power supply. However I have a concern on how to wire the input. I see that it is designed to opera...

Does it matter if I use AC or DC on the analog signal?

#2  KIMG0810.JPG

Picture  KIMG0813.JPG

I am not sure that the controller is PWM calling it that was ignorant on my part. I do not even know what a PWM is, I am very new to this and it is s...

I am near completion with this project. Now at the point that I most feared, hooking everything up without frying my purchase. I am enclosing photos ...

The Dyno was sold by Snap On Tools / Sun originally to check emissions and do driver simulations. Model is RG240P also as EESE101A. It is portable...