Q&A Forum

Ok thanks. Yourdyno finally turned up this week after been held in customs! I have a to make a trigger wheel that will fit onto input shaft between...

Hi what were your thoughts on the flow valve thanks?

Do you think adding another 3 magnets to the rotor to give me 4 will be enough pickups? Thanks Austin  16056184816485838690724215239641.jpg

Valve  20201117_113257.jpg

Valve valve  16056176291092127300955693370800.jpg

Valve  20201117_113331.jpg

Couple of pics of valve! Just a ball and seat quite basic!

Thanks for the replies. The valve i have as almost 2 complete turns from closed to open! Presumably this will not be a problem? I am going t...

Thanks for getting back to me! I had not thought of making making a arm to use that type load cell! But as I have the L&S trolley makes good sen...

Hi Glenn have you had any joy in getting readings from your strain gauge yet? Would like to do the same as I have a similar L&S kart setup but dat...