Q&A Forum

Jostein, I work with Benjamin (benVielmi). What we need is what is described here and in the following posts. Currently, the software is ma...

Hello, About recording automatically or manually, this behaviour could be extended to the manual mode. The keystroke for recoding will be common to ...

Hi, And obviously, recording should be done only when RPM is stable enough. Or it is done by a second button/keystroke, so we can choose manualy w...

Hello Jostein, It is exactly what I need. Using the sequencer is better. I can insert some points with low RPM/low load, to add some cooling down ph...

Hello, I second Rub87, we definitely need a "mapping mode", for ECU mapping. It will be usefull for ECU mapping, where we setup RPM and load to th...

Could be a solution, but the PC driving the controller have no access to internet. And everything is often powered off. A third solution would be ...

OK, removing unused code and moving to 3.3.40 solved the problem. Angelo

Hi, Thank you for your support. Erasing the file is the solution. I can't remember when the problem occured. Corrupted file is available if you w...

Hi, Some interesting progress. I used another PC where Yourdyno was never installed. And ......... everything Ok and run as it should ???? ???? ??...

When I try to install the new software versions, Avast antivirus (free version) complain about it, verify it, send it to Avast. At the end the install...

Here is a screenshot:  20230507_174811.jpg

Box IS connected, AND working. Themo-couples values are changing in the setup, I can make the stepper motor move in the setup, i can see CAN traffic. ...

Hello, All gauges are 0.00. Thermo-couples values are visible in the setup (option menu) Aux inputs: no sensors connected but even the small noi...