Q&A Forum

2Smoke
@2smoke
Member
Topics: 6 / Replies: 10
Reply
RE: Interference sending the gauges wild!

Thankyou, I'll give it some work. Didnt think about earthing the bike! Paul

9 months ago
Reply
RE: High drum rpm and no increase in speed reading.

Ok, so setting the gear ratio seems to have solved this. Torque seems a little too high now. But have more bikes to test next week.

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

So, still no joy with the drum rpm, but the HP is accurate now with some fettling of the MOI and using a bike with a known HP figure, The engine...

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

Not yet, haven't had much of a chance but I'm going to have a play tomorrow. Suspect the MOI is out!

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

Smashing thankyou. Thats made a difference, but my live HP reading is still very low. I've not done a power run yet as am still running in, but its ba...

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

Ok so seems I forgot to set the gear ratio in yourdyno. Have done that now and the drum rpm is reading better, but still no speed increase.

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

And my toothed wheel setup  411497614_10160220225897701_1619835173772948648_n.jpg

11 months ago
Reply
RE: High drum rpm and no increase in speed reading.

More engine RPM but very little increase in speed, the drum RPM has risen considerably though.  412006337_10160220225942701_3299511899860751806...

11 months ago
Reply
RE: Yourdyno v5 installation onto a Dynojet 200i Questions about ignition rpm & lambda

Thanks for the reply, can I use the old dynojet inductive leads if they've been de-pinned? What voltage should I see at the pins? And when you s...

1 year ago
Page 1 / 2
Select your currency
EUR Euro
USD United States (US) dollar