Q&A Forum

@cmadmin Ahh yes of course... knew I was missing something obvious. Guessing it wasn't saved to the settings from the old on.. Thanks!

Hi, I have done exactly that. Working very well after some teething issues! I fitted a 24 tooth trigger wheel, then used a cherry hall effect s...

I've literally just been reading and have ordered one. Thankyou!

Okay, and how would I go about working this via Yourdyno? Or does it need a seperate software? Thanks Paul 🙂

@danny_530 I did, or seem to have. I've earthed everything. And I mean everything to the YD unit, dyno, afr module, ducting, fans, the bike, m...

Thankyou, I'll give it some work. Didnt think about earthing the bike! Paul

Ok, so setting the gear ratio seems to have solved this. Torque seems a little too high now. But have more bikes to test next week.

So, still no joy with the drum rpm, but the HP is accurate now with some fettling of the MOI and using a bike with a known HP figure, The engine...

Not yet, haven't had much of a chance but I'm going to have a play tomorrow. Suspect the MOI is out!

Smashing thankyou. Thats made a difference, but my live HP reading is still very low. I've not done a power run yet as am still running in, but its ba...