Q&A Forum
Hey!
So, just installed my yourdyno kit. Everything works like a charm, except my torque figure is jumping between some negative number and aprox 10nm. Even if nothing is on the dyno.
Is this normal? Or could it be a badly shielded cable from the loadcell?
Thanks in advance!
Jørn Andersen
Hi,
It is normal if you have not calibrated yet! But after calibration it should hover around 0 with very small changes.
Also make sure you have turned on only 1 load cell in Options if that is what you have and check the RPM settings. If RPM2 must be set to "Not used" or "Engine RPM" if you only use 1 load cell.
Cheers!
You can also watch the raw reading in the calibration window. The raw value will normally vary about +/-10 or thereabouts with the engine off. This is on a raw scale from -32000 to +32000 so it will translate into very little noise.