Q&A Forum

Notifications
Clear all

Telma installation

5 Posts
5 Users
0 Likes
3,542 Views
(@migi46)
Posts: 1
Member
Topic starter
 

Hello friends.

Are anybody install telma axial retarder on the dyno? I hope yes.

On the ends of telma are KV - XS flange like connection for driveshaft of the truck.

How can I convert these flages for longer shaft, preparing for pillow block bearing and next shaft connection.

On the Telma.com they write about test benches, but nothing about it how to do it.

I´m looking for your help.

https://www.telma.com/applications/industriel

 
Posted : 02/02/2019 12:09 am
(@kristovey)
Posts: 11
Member
 

Hi,

Assuming you are talking about the same retarder I am using, This is how I have mine set up. I drew and turned up some spindles that bolt onto the flanges that accept some pillow block bearings. I hope these pictures are helpful and PM me if you want the drawings.

[img] [/img]

[img] [/img]

Kris

This post was modified 5 years ago by kristovey
 
Posted : 05/03/2019 9:31 pm
(@prietobmiguel)
Posts: 1
Member
 

Hello ,

I'm trying ot build my first dyno. I have the same retarder , and have also purchased a SportDevices Brake power Supply PWS3.2

We have put the the 6 coils 12V in series  to have 72V  and 14,15 amp.

Today we have tested and the retarder seems not to work. I was not present and will check if we have something wrong wired,  but  it's ok to put the power supply to 70Volts and limit to 14 amps ?

thank you in advance for your support

 

 

 

 

 
Posted : 19/03/2019 8:28 pm
(@boroko)
Posts: 4
Member
 

I'm looking to do this also, but with a CC135 retarder, if anyone has any suggestions.

Thanks

bo

 
Posted : 06/04/2021 9:22 am
(@matteozanusso)
Posts: 22
Member Customer
 

Did someone manage to use that kind of telma retarder?

 
Posted : 12/04/2021 10:48 pm
Share:
Select your currency