Q&A Forum
looking to start a clean sheet of paper project using a 901 brake as a starting point, only the the mechanics, no SF electronics, a new stand alone OS. Need servo, etc.
Thoughts....
Hi, we have a kit for that! You keep the mechanical parts of the valve, and replace the servo with YourDyno's and replace the Superflow DAQ.
You can reuse the load cell if you prefer and the RPM sensor, or replace them. Most of the time they are reused without issue. The kit includes instructions on how to hook them up.
Give me (jostein@yourdyno.com, +47 4840 1279) or Kevin Hamilton (kevin@yourdyno.com, +1 (603) 491-5961) a call and we can discuss options.
@admin
What do i need to connect my SF 902 rpm sensor, and air and fuel tubines, also SF to the box?
Hi,
The Superflow RPM sensor can be connected directly to the VR RPM input on the YourDyno Ultimate.
The air and fuel turbines can be connected to the Freq1 and Freq2 inputs. You need to know the number of pulses per unit of flow.
no combination of the 3 leads from the SF rpm sensor to the vr rpm inputs results in rpm signal, any thoughts?
can you supply the correct wiring for hooking the rpm,and turbine sensors to the box, my kit had no instructions for that.
Check that the RPM1 jumper inside the box is on VR, not Digital