Q&A Forum
Questions, answers and shared experiences
2
Posts
2
Users
0
Reactions
33
Views
Topic starter
when doing a pull when it reaches 6000 rpm the screen goes blank and then comes back on after its done
Posted : 21/05/2025 5:48 pm
This is normally a problem between the PC and the monitor, caused by bad cables or vibration. I have seen this in a couple of setups, where all looks good when monitoring the PC by remote login, while the physical monitor flickers. It has been fixed by replacing the HDMI cable or power cord or similar.
Posted : 22/05/2025 10:14 am