Q&A Forum
hi
first question on the forum 🙂
i was wondering if i can use the 2 rpm inputs on the front and rear roller on a 2wd dyno?
how does the software deal with that?
the reason is that i would like to see if the tire deformation does give different speed on the rollers.
Install the Brake and Gear ratio plugin
How I have to do this?
rpm setup- rpm input function :load cell 1+2 rpm?
If you have two RPM sensors on the rollers, then plot RPM1 - RPM2.
Are there a plug-in for tyre slipping identification now?
Thanks
It would be fun to se the results of the difference in front and rear roller
Hi,
With a very minor change a slip measurement plugin can be made. I will do it.
Hi yes thats what i think is the problem
Because when you accelerate on the front roller only
And calculate the loss on retardaion
You are on 2 rollers.
How are you strapping the car down.
On my which is 2 rollers when you have a perfect strap down the rear roller doesnt contact the tyre under full load since the car rolls up onto the front roller which has the brake on it.