Q&A Forum

Notifications
Clear all

RPM Curve

4 Posts
2 Users
0 Likes
1,519 Views
(@vandame49)
Posts: 17
Member
Topic starter
 

Excuseme, i want to know how to use RPM Curve for brake control, when running the car do we have to follow the curve that we make or just do Wide open Throtle? 

Thank you

 
Posted : 29/10/2019 9:43 am
(@admin)
Posts: 1397
Member Admin
 

Hi, use full throttle, YourDyno will ensure the rpm follows the curve! 

 
Posted : 29/10/2019 10:15 am
(@vandame49)
Posts: 17
Member
Topic starter
 

Thank you for the answer, i want to know whether the curve that I made is correct or not . i want to dyno fortuner car with spec. 120 kw @3400 rpm.

This post was modified 4 years ago by vandame49
 
Posted : 21/11/2019 6:15 am
(@admin)
Posts: 1397
Member Admin
 

@vandame49

Almost good, but two points:

  1. The "Start logging after" timeout should match the flat part in the beginning, otherwise you get some strange effects in the beginning when the RPM stabilizes. 
  2. You don't need the flat part at the end.
    • If you have enabled "Enable correction for rolling resistance vs speed from retardation data", then then brake turns off at the end of the curve
    • If you do not enable this option, the brake stays on to regulate the end RPM

You can alternatively use the Power sweep for a regular power sweep like this.

 

 
Posted : 21/11/2019 6:10 pm
Share:
Select your currency