RPM Curve  

  RSS
(@vandame49)
Member

Excuseme, i want to know how to use RPM Curve for brake control, when running the car do we have to follow the curve that we make or just do Wide open Throtle? 

Thank you

Quote
Posted : 29/10/2019 8:43 am
(@admin)
Member Admin

Hi, use full throttle, YourDyno will ensure the rpm follows the curve! 

This post was modified 3 months ago by admin
ReplyQuote
Posted : 29/10/2019 9:15 am
(@vandame49)
Member

Thank you for the answer, i want to know whether the curve that I made is correct or not . i want to dyno fortuner car with spec. 120 kw @3400 rpm.

This post was modified 2 months ago by vandame49
ReplyQuote
Posted : 21/11/2019 5:15 am
(@admin)
Member Admin

@vandame49

Almost good, but two points:

  1. The "Start logging after" timeout should match the flat part in the beginning, otherwise you get some strange effects in the beginning when the RPM stabilizes. 
  2. You don't need the flat part at the end.
    • If you have enabled "Enable correction for rolling resistance vs speed from retardation data", then then brake turns off at the end of the curve
    • If you do not enable this option, the brake stays on to regulate the end RPM

You can alternatively use the Power sweep for a regular power sweep like this.

 

ReplyQuote
Posted : 21/11/2019 5:10 pm
Share:
Select your currency
NOK Norwegian krone
EUR Euro
  
Working

Please Login or Register