Q&A Forum
Hello,
I have the issue that i measure a reverse power in my diagram.
I have done following steps:
1. created a new folder
2. calibrate the load cell
3. upgraded the software from the latest stable to the actually beta
4. upgraded the controller Firmware (Yourdyno V5 Ultimate)
When i do a run the Gauges seems like to work right, but the diagramm starts under the zero line.
Is it a Software issue or something other?
I atached a Screenshot.
The dyno seems like to work without any issue.
I don´t have a electric starter engine at my dyno which could run 😉
Thank you very much
Best regards,
Daniel
Hello,
The problem here was too short retardation phase. When measuring the retardation drag/losses, you need to let the car coast down to the start RPM
Hello,
Yes you are right. I am forgotten to write here that the issue is solved.
Thank you very much.