Q&A Forum

Notifications

Clear all

Electrical connection on retarder, KLAM CFK500

Questions, answers and shared experiences

Last Post by MadsWP 4 years ago

3 Posts

3 Users

0 Reactions

1,402 Views

RSS

Dennis Jensen

(@dennis-jensen)

Posts: 1

Member Customer

Topic starter

Hi all,

I'm about to connect the 192V power supply to my brakes, but got a bit confused when I looked at the brakes and the drawings from the manufacture. See below pictures and PDF file.

The obviously place to connect the power supply on the brakes are on the two bigger bolts, but then I don't think the drawing and brakes matches very good and the latches are installed from factory, but they are not matching the drawing.

https://ibb.co/JnnfYw8

Any comments or advices would be appreciated 🙂

This topic was modified 4 years ago 3 times by Dennis Jensen

Posted : 28/11/2020 5:17 pm

GSE_UK

(@gse_uk)

Posts: 15

Member

The connections are shown on different poles in the PDF but the photos look right too. Put a meter across the 2 larger poles and you should have a reading of 10.08 Ohms from the spec in the PDF

Hope this helps

Posted : 30/11/2020 5:46 pm

MadsWP

(@madswp)

Posts: 52

Member

What kind of brake do you got? uploaded files are no longer avaliable.

Posted : 21/12/2020 7:52 pm

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed

Q&A Forum

Electrical connection on retarder, KLAM CFK500

Have Questions?

Address