Hi,

You can zoom in and out with the mouse (left button and drag) or the mouse wheel. You can also right-click and choose Unzoom, etc.

At the bottom is the list of the runs. Temperature, pressure, time/day, etc comes from the run, you cannot change that. You can still rename the run by clicking on the name and writing something else. You can also click on the colors in the table and change colors. 

You will get used to it!

Cheers,
Jostein

So all the changes have to be made after a run while connected to the hardware?  Because none of that works on my software but i don't have the hardware yet . And have no run recorded.  Click and drag moves the cross hair but does nothing, the graph does not change.  No luck changing the numbers on the graph either

You can't change the scale of power/torque really.  Click on set Scale to default. 

The scale is automatically corrected after a run, after a run you can also zoom in/out. This works fine, dont worry 🙂

Thanks , I'll stop playing till i get the hardware then .