Q&A Forum
Hello Guys,
I run a Golf 2 on a KMS MD35 on my Dyno with all the Can Bus ID a half year ago.
Now i updatet the YourDyno Software and all the ID´s are gone. Its not the Problem to write new, but my Question is (Can i safe the ID so its when i Update Yourdyno not away like a Backup or to load a File that all ID is in. The best way it shoulden not delet).
Or made I somting wrong?
Hi,
Did you update to the latest software (3.2.162)? This shall not happen, the CAN tool configuration shall not be overwritten by the installer. I will need to look into this if that is the case. This no-overwrite flag was introduced a few versions ago, but it could happen earlier.
The setup is stored in this file: C:\ProgramData\YourDynoPlugins\ControlCAN.dll.json. You can make a backup of it.