Q&A Forum
hello to all
I have yourdyno ultimate my problem is i want to read can bus straight from ecu (ecumaster black) how I'm going to config I don't know I can read the can bus from ecu but can't reading on gauges thanks in advanced
Hi,
By far the easiest way is to ask EcuMaster for the CAN bus .dbc file. This can be read into YourDyno, and all channels are automatically configured.
If they don't provide a .dbc file, then the channels need to be configured manually. This is not a problem either but you need the CAN bus configuration from ECU master. This is normally available in the ECU software, and consists of things like CAN address, bit length and position, offset and gain, etc. that are typed into the YourDyno program. I can help you configure it if you get this info. But check first for a .dbc file.
This is the Ecumaster values i figured out tps but it’s oscillating
That can be used as information to define the channels. Let me know if you need any help and i can do it. Message me directly on Whatsapp: +47 4840 1279