Q&A Forum
Notifications
Clear all
Topic starter
I was wondering if there is a mode where the eddy brake is completely engaged at minimal rpm to unload a vehicle. And if there is could it be programmed as a hot key.
Posted : 24/08/2022 7:21 pm
I think this has come up a few times.
I used to use the brake test slider in the configuration options, but now I have set up a relay controlled by a windows DOS batch script and initiated by a hotkey that applies 5v (full load signal) to my 0-5v brake controller for 30 seconds control.
Kinda clunky but it works....
Posted : 02/09/2022 7:04 am
Hi! Hotkey for load/unload is coming in the next software release, which will be available today!
Posted : 02/09/2022 7:58 am
Fantastic! Thank you Jostein
Posted : 02/09/2022 8:00 am