Q&A Forum

Forums
YourDyno forum
Questions, answers ...
Auto start and swee...
 
Notifications
Clear all

Auto start and sweep

 
Questions, answers and shared experiences
5 Posts
2 Users
2 Reactions
1,108 Views
RSS
 Manyponies
(@manyponies)
Posts: 40
Member
Topic starter
 

Can the auto start and stop for the logging rpm be separated from the brake control mode rpm?.  When they are exactly the same start and stop of the gragh gets a little messy .    if the engine has had a chance begin the sweep and the logging stop just before the end of the sweep the gragh will be "cleaner" on the ends.    With  a water brake using load control the brake is trying to stop the sweep and the logging continues.     

 

Thanks, Mark

This topic was modified 2 years ago by Manyponies
 
Posted : 28/07/2022 2:01 am
 boz race engines
(@boz-race-engines)
Posts: 117
Member
 

it should be set on load control for a water brake and stop logging at what ever stop sweep setting is set at in load control section. control loop setup also has affect when load control or any other type of control is being used, i usually use around 70-80% brake apply at end of my runs, the peak rpm must be reached to end run or it will keep logging. 

 
Posted : 29/07/2022 5:17 am
Thdyno reacted
 boz race engines
(@boz-race-engines)
Posts: 117
Member
 

here is a run i did yesterday, you can hear the brake apply 70% at end of run, then it stops logging as soon as sweep setting max is reached

Facebook

 
Posted : 29/07/2022 5:23 am
Thdyno reacted
 boz race engines
(@boz-race-engines)
Posts: 117
Member
 

here are my settings

 

 
Posted : 29/07/2022 5:33 am
 boz race engines
(@boz-race-engines)
Posts: 117
Member
 

here are my settings

 

 
Posted : 29/07/2022 6:08 am
Forum Jump:
  Previous Topic
Next Topic  
Share:
Select your currency
NOK Norwegian krone
EUR Euro
USD United States (US) dollar