Q&A Forum
Notifications
Clear all
Topic starter
Hi !
Im looking to change the controller and software of my inertia dyno and have found your solution.
I like to work in lambda only as AFR is different between different fuels .
Is it at all possible to get the software to display as lambda instead of AFR .... Its kind of a dealbreaker for me 😀
Tack för svar !
Posted : 21/11/2021 11:31 am
Hey,
Yes for sure! You can program the Aux channels to show anything, the default is just an example. Type in the Sensor type and Unit (if any) and set the translation between voltage and reading and you are good to go.
Cheers
Posted : 21/11/2021 11:46 am
Topic starter
@admin but it reports it in LAMBDA not in AFR (not 14.7 that is for gas but 1)
Posted : 21/11/2021 8:14 pm