Hi, 

Hotkeys are not supported for the KMTronic yet. You can set it to trigger based on data channels though. 

Hotkey support for the KMTronic has been on the plans for a while, it needs to be supported, I agree!

Cheers

@admin i am happy that i noticed something that need to be done already even if i havent receive my equipment yet.i will say that of course i can turn on-off the fans and the extraction system with variables such rpm but ramps absolutely needs a hotkey to activate.waiting for the updates 😉

Hi,

I have implemented hotkeys for plugins now, among them the KMTronic. Will be available on the next release!

@admin thats great waiting for the new release till then hope to have got my kit.

The hotkeys are released now with the YourDyno 3.2.160 software 🙂

Thank you for adding these functions.

We have the "USB Relay beta 1.0" Plugin running with the 8 relay board.

Would it be possible to add the hot-key function to this relay plugin also?

Or should we just buy the KMTronic relay board instead?

Hi,

For sure I would buy the KMTronic relay board. This is a much better solution than the USB relay board, and very reasonably priced. 

Thank you for the fast reply.

I ordered the KMTronic USB relay board and received it very fast.

The costs where higher (€59 including shipping) as the other USB relay board (€18 including shipping).

We tried to add the Plugin, but was not succesfull.

So we removed the Yourdyno software and re-installed with the KMTronic Plugin selected, that worked great.

We can now use our wireless keyboard for switching the fans  😀

hello all, i have a kmtronic too and work great on the new software.

But before to use it , i need to have one relay in 12v and an other in 220v. I don't find where can i configure the differents voltage of the output ?

thanks

Hi, no problem to mix and match. The relays are separate, and each relay can either close or open the two connections.