Q&A Forum
Not sure if this is the place for this. I plan to have the YourDyno controller activate my pump for the water brake when the rollers start to spin. I was wondering if it's possible to change a gauge readout for relay0 to be an indicator light instead? I couldn't figure out a way to do it so if it currently isn't possible could that option be added? There is no way I will hear the pump come on with ear muffs and the engine running.
I have a hydraulic brake but what I installed is a pressure sensor and it is a gauge on my display right beside brake %.
I also have the 3rd party relay plug in that stays on top always and it shows if the relay is on or off.
@bigpermgarage I do have a pressure sensor for the brake that I guess would be an indicator. I also considered an LED wired to the trigger wires for the pump. I may do that if a light on the screen isn’t possible