Q&A Forum

Mounting point on load cell  20210815_204716.jpg

The spring🙂  20210815_204744.jpg

Here is the lever im using. The spring under the lever is to compensate for its weight.  20210815_204716.jpg

ĹOk. Thanks for the answer. The sensor is about 10mbar low. I dont think it matters that much on hp correction. Reason why i asked is that i w...

Ok. Thanks for the answer. The sensor is about 10mbar low. I dont think it matters that much on hp correction. Reason why i asked is that i wo...

@chipg1956 Im using a 1mtr. Lever and load it with 70kg. I will try to post a picture later today

Im using the maha loadcell with yourdyno It works perfekt🙂

@mach_1 Hi. Yes i have read that🙂 But i will try adjusting again. I will reply when i get to try it again. Thanks

@devolkswagenman Thanks. I will try to wire i up later this weekend.

Here is a picture of the wiring from maha  20201003_083729.jpg

@admin Hi I did see the help page on load cells I was in doubt about the maha diagram It says -5v ref. But acording to your diagram that mus...