Q&A Forum

where do you get the new pulleys and how much do they cost

cool great to see it works and was not any expensive adaptors just a $5 part to make it work

i can't wait to see how you make this work as i want to buy one

there is a electric motor on my dyno with a thin belt that goes to the rollers and could spin things up also my dyno has some airbags to lift part of ...

anyone know how to make the warm up motor work i took a look at what i think are the wires that control it one said V+ the 2 others say forward and re...

? while setting up the load cell i see Dyno/drivetrain Moment of inertia Hub / Roller is this the inertia weight as i have not been able to find what ...

has anyone used this for engine rpm MSD Ignition 8918 Tach Signal GMR Pickup this is the inf on it OverviewTachometer Signal Pickup Tach Sig...

Ok the brake is working now i just need to wire the roller rpm and load sensors it is really simple once you find the info you need

I finally talked talked to a guy on DIY Dyno on facebook and me told me how to wire it up on analog out the ground wire goes to 0V and the signal goe...

hi just need a bit of help i have a old Mustang emission dyno and the power supply works with a 0-5v signal and there are 3 wires going to the board I...