Q&A Forum

Hi, I tried this setup, the servo turn about 8 turns but have no necessary torque to complete rotate the oleodinamic pressure valve (problem is the ...

Hi, I have the necessity to rotate the servo hitec Hs785hb about 8 turns from zero, but with the setting above it turns only 6 turns from zero. Could ...

The dimensions of theets in photo mustn't be followed with extreme precisione correct? teeth.jpg

For automatic brake. It's only to polished. IMG_20180307_184904.jpg

Hi jostein, what do you think about this wheel? 28 thoots. IMG_20180307_184838.jpg

Ok, now works correctly, Thanks a lot!

Do you mean to remove the rim circled? Or the thoots of wheel? Sorry but I can not understand which other thoots i should remove

Do you mean to remove the rim circled? Or the thoots of wheel? Sorry but I can not understand which other thoots i should remove Thanks Eric IMG_20...

Sorry, can you explain me wich other tooths are to grind off? You are very patient and kind

Ok, is necessary that wheel Follow the spec in photo. I think it is so difficult find a wheel that Follow these spec. Could you suggest me any website...

I Will make dyno with automatic brake control. Im going to buy a Steel timing belt pulley. I have found one with 68 tooths and 5mm pitch, look The lin...