Q&A Forum

The brake is controlled by the SCR transistors. The part of the board that controls the SCR's was cut out of the original brake controller. It was 90'...

I have an update with the dyno pwm output. Here is a video showing the connections for the pwm output. PWMout Here is a video showing the function of...

Here is the Voltage reading from the %30 test with a volt meter. I want to put it on my scope to see the signal but I don't think it is necessary. If ...

I bought mine in 2017 so I believe my terminals don't exist. So I believe the signal is never getting to the output pin. It must just be the pullup th...

Okay tank you. Would it be on the other side of the pcb? I don’t see a jumper by the pwm output. I have the rev 2 ab green board.

I was wondering if you had a diagram that shows how to connect my existing loadcell to the your Dino acquisition controller. I just want to make sure ...

Posted by: admin Hi, The new kits support an optional second RPM input. It uses a 0-5V signal. To use an inductive rpm sensor, you need a converter t...

Posted by: admin Hi Larry, The RPM sensor senses any ferrous (iron based) material. You do not need to use a magnet. For Brake dynos, a simple bolt o...

I just ordered my acquisition kit. I have been getting familiar with the software and I like how easy it is to use. I look forward to hooking everythi...