Hi:

I have an Eddy Current Dyno and Big Inertia Wheel Dyno that i use for tuning drag sleds.  I would like to have these sensors:

- Fuel Flow (i have a fuel flow transducer and pulse to analog converter)

- Engine RPM (i have the dtec adapter)

- Wideband (i have the spartan 2 and controller)

- Encoder for big wheel (360PPR 5V max wheel speed 1800rpm) and 40PPR encoder for eddy current dyno

- Air manifold pressure

- Fuel pressure

- Water Temp (coolant)

- Pipe back pressure

- Exhaust temp

- EGT 1

- EGT 2

- And a couple or relays related to inertia wheel rpm (safety brake and vibration switch)

I have a velleman VM167, 4 cards to convert EGT to analogue, a pulse to analogue board for the fuel flow, a usb relay board.

Would it be possible to get a quick wiring sketch to make sure i have this figured out properly ?

ALSO, is it possible to us the BUS add on to use a plex knock monitor ?

Thanks.

Dave 😀