Q&A Forum
Notifications
Clear all
Topic starter
Hi, I have a manual controlled GoPower water brake fitted with YourDyno instrumentation kit (which is used for Data only at the moment). I am fitting an automatic load valve which should make repeatable runs easier. Can I fit the load valve to the wall in my dyno room and use a 2 meter hose to the dyno or does it need to be closer? I'm trying to keep the engine/dyno stand as clutter free as possible to make engine fitting quick and simple.
Posted : 16/01/2021 7:38 pm
Hi, closer is better for immediate reaction to changing valve setting. But I expect 2 meters will work fine. If you have very abrupt torque curve or other tricky regulator challenges, then maybe not, but in most cases I expect it to be ok.
Posted : 16/01/2021 9:22 pm