Q&A Forum
when pulling a engine on the back of the absorber there a air vent adapter with a tube coming down to it shoot out water when i do i pull water shoots out like crazy sprays everywhere .Is that right i have a pic of the tube attched
The water coming out of the small vent is normal. You should put some sort of hose to keep that water from splashing everywhere on the electronics of the valve. As for that blow back of water it appears that your return pump is not working properly. I would check its volume
when i do a pull water comes out of the vent like crazy i dont remember seeing it like that but i will check the return
i checked return working great. our supply tank is full of water when you do a pull you can see in the video that the water stops coming out of the valve and then once you stop pulling the motor. That's when the valve shoots out water again and shoots back in the air .
The valve will go full open when the test is complete, the SF 901 is outlet controlled. You should have a splash guard on the top of the tank to avoid splash back, but I still do not think the pump is working at max capacity. If it was, the tank would have a low level and the burst of water from the valve would have no effect